I just tested my RFID Module with Hyper Terminal

Since my project needs to communicate RFID through UART, I first   tested with the system RS232 port.  The test is successful.  I used USB-RS232 converter for my laptop since it doesn’t have any serial port on it…  The hell part happened on my side to find the driver for the converter.  Finally I found it on a very damaged CD and backed up on my online drive.  If you people also have any driver scarcity means, I can give you. 

Busied Up With Project

Today I started with the mesh of ideas to complete the hardware side of the project.  I started to work with it from 0700 hrs itself.  And now here is the picture of my messy electronic world.

 

And Finally interconnected and tested the LCD module with PSoC uC on breadboard.

Now the task is to comm. using UART

UART Protocol is used to comm. b/w RFID DT125 module and microcontroller.  For that I decided to test the UART device comm. b/w two PSoC devices.  I’m going to test it on the CY3209EVK kit.

New project with PSoC

I started this project about 2 weeks before and now on the track to integrate RFID module to Cypress PSoC devices using UART protocol.  The project is to create an embedded module which can read RFID tags at the trolley when the products are dropped in and logged in the LCD module on the same system.  When the trolley comes to billing section, it should transfer the logged data to the billing computer to bill the amount.  That’s it.  Hope my project will end up on the first week of Feb. i.e., by 7th of Feb 2009